Commands:

exit - Exit the voltpeek program.

connect {scope identifier} - Connect voltpeek to an oscilloscope. For example "connect NS1" would be used to connect to the NS1.

auto - Auto Trigger the oscilloscope. This will continuously retrigger the scope without a trigger event.

normal - Normal Trigger the oscilloscope. This will continuously retrigger the scope, but only when there is a trigger event.

single - Single Trigger the oscilloscope. This will capture a single waveform when there is a trigger event.

stop - Stop any armed or continues trigger.

scale - Enter adjust mode to adjust the horizontal and vertical scales.

triglevel - Enter adjust mode to adjust the trigger level.

trigrising - Trigger on a rising edge.

trigfalling - Trigger on a falling edge.

togglecurs - Toggle both the horizontal and vertical cursors.

togglehcurs - Toggle just the horizontal cursors.

togglevcurs - Toggle just the vertical cursors.

nextcurs - Increment the selected cursor.

adjustcurs - Enter adjust mode to adjust the selected cursor.

probe1 - Multiply readings and scales by 1.

probe10 - Multiply readings and scales by 10.

cal - Recalibrate the oscilloscope offsets. Scope input must be disconnected.

png - Export a png of the current graticule display.